|
THE 3DWAXMILLER CLUB. A place to share your experiences with your 3dwaxmill system. 3D Wax Mill
|
View previous topic :: View next topic |
Author |
Message |
ToddMichael
Joined: 21 Jun 2008 Posts: 611 Location: Detroit, MI
|
Posted: Thu May 27, 2010 9:50 am Post subject: Show your Rig, or MDX-15 or 20 set-up? |
|
|
Curious to see other set-ups!
In reading through a lot of post I hear of alignment concerns and questions.
I have 3 plates now.
1. Rotary
2. Flat I made with wooden watch vise
3. and now the flipper
Questions I have heard and read are.
1. Leaving the 3D wax mill rail on.
2. Using the short shaft.
3. making the flipper 1/4 to 12 shorter on left to accommodate the 3d Rail
4. forth axis attachment
Would you mind showing your everyday set up and your special set ups to show us newbies other options for leaving our rigs set up?
Todd Michael
Description: |
|
Filesize: |
95.74 KB |
Viewed: |
11338 Time(s) |
|
Description: |
This one, I ordered a plate from Roland, and glued a old watch, or engravers plate to and drilled a few holding pins into. Must have been the humidity, double back tape never held on long jobs, and hot glue, well sometimes broke the wax when removing. |
|
Filesize: |
87.24 KB |
Viewed: |
11338 Time(s) |
|
|
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You can download files in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|